Even More... Sculpting an Ambull

First half of the mold is poured. I do not yet have access to vacuum and pressure chambers, so it does make molding and casting a little difficult. I've done larger things before, but certainly nothing this detailed. In a case like this I simply drizzle a thin layer over the most crucial part of the mold and let it settle a little, doing as best a job to make sure the bubbles are gone. This is allowed to cure, whereupon subsequent layers can be added without too much concern for bubbles (as these would simply fill out the bulk of the mold).

Drizzle:

Drippy - This was allowed to cure before more rubber went on top:

Blobby: